Tips & Tricks

Air Conditioning Tips & Tricks You Must Know!


Here are a few simple tips and steps that can end up saving you a lot of money when it comes to running your air conditioner.

  • Try setting your thermostat between 72°F and 78°F. Each degree setting below 78°F will increase your energy consumption by approximately 8%. As you can see, that can add up to a lot of money over a year.
  • Inspect and clean both the indoor and outdoor AC/Heating coils. The indoor coil in your air conditioner acts as a magnet for dust because it is constantly wetted during the cooling season. Dirt build-up on the indoor coil is the single most common cause of poor efficiency. The outdoor coil must also be checked periodically for dirt build-up and cleaned if necessary.
  • Check the refrigerant charge. The circulating fluid in your air conditioner is a special refrigerant gas that is put in when the system is installed. If the system is overcharged or undercharged with refrigerant, it will not work properly. You may need a service contractor to check the fluid and adjust it appropriately.
  • Use bath and kitchen fans sparsely when you are running the air conditioning system.
  • Reduce the cooling load by using cost-effective conservation measures. For example, effectively shade east and west windows. When possible, delay heat-generating activities, such as dishwashing or baking, until the evening on hot days.
  • Try to not use a dehumidifier at the same time your air conditioner is operating. The dehumidifier will increase the cooling load and force the air conditioner to work harder, which in turn increases your utility bill.
  • Over most of the cooling season, keep the house closed tight during the day. Don’t let in unwanted heat and humidity. If practical, ventilate at night either naturally or with fans.

Room Air Conditioning Units

  • The unit should be level when installed, so that the inside drainage system and other mechanisms operate efficiently. If possible, install the unit in a shaded spot on your home’s north or east side. Direct sunshine on the unit’s outdoor heat exchanger decreases efficiency by as much as 10%. You can plant trees and shrubs to shade the air conditioner, but do not block the airflow.
  • Set the fan speed on high, except on very humid days. When humidity is high, set the fan speed on low for more comfort. The low speed on humid days will cool your home better and will remove more moisture from the air because of slower air movement through the cooling equipment. Consider using an interior fan in conjunction with your window air conditioner to spread the cooled air more effectively through your home without greatly increasing electricity use.
  • Set your air conditioner’s thermostat as high as comfortably possible in the summer. The less difference between the indoor and outdoor temperatures, the lower your overall cooling bill will be. And don’t set your thermostat at a slighter setting than normal when you turn on your air conditioner. It will not cool your home any faster and could result in excessive cooling and, therefore, unnecessary expense.
  • Don’t place lamps or televisions near your air-conditioner’s thermostat. The thermostat senses heat from these appliances, which can cause the air conditioner to run longer than necessary.
  • In the winter, either cover your room air conditioner or remove and store it.
    Proper maintenance of your air conditioner will also save energy. Be sure to do the following:
  • At the start of each cooling season, inspect the seal between the air conditioner and the window frame to ensure it makes contact with the unit’s metal case. Moisture can damage this seal, allowing cool air to escape from your house.
  • Check your unit’s air filter once a month and clean or replace filters as necessary. Keeping the filter clean can lower your air conditioner’s energy consumption by 5% to 15%.
  • Occasionally pass a stiff wire through the unit’s drain channels. Clogged drain channels prevent a unit from reducing humidity, and the resulting excess moisture may discolor walls or carpet.
Take heed of
the following tips
Cold storage efficiency is essential if you want to maintain the quality of your products – to further maximise your profits.
#1: Clean Your Condenser Unit

Debris can accumulate in the fan and condenser of your cooling equipment – this can hinder performance. Make sure it is cleaned on a regular basis.

#2: Check the Evaporator Coils

For maximum cooling benefits, make sure your evaporator coils are clean and free from any restrictions that might affect airflow.

#3: Examine the Condition of Your Building

Faulty roofing and cracked walls can affect your cold storage equipment – letting the cool air escape. This makes it harder for the condenser units to control and maintain the desired cold room temperature.

#4: Choose Appropriate Lighting

Costs are greatly reduced when you use the appropriate lighting, since it minimises energy consumption. Instead of using floodlights that use almost 400 Watts, LED lights can be a more practical alternative – using an average of 120 to 150 Watts.

#5: Keep an Eye on the Inside Temperature

By constantly monitoring the temperature inside your cold storage facility, you will be able to establish if and when you need to contact a consultant. Possible cooling system issues can also be determined by checking the temperature’s regularity.

#6: Consider Your Door Design and Seals

With the loss of refrigerated air, condenser units are required to work harder to replace it – this drives up power consumption. For a reliable performance, make sure that your door and seals are adequate.
Truly efficient cold storage facilities do not require you to pay astronomical energy costs. Art of Happiness builds reliable and cost-effective cold rooms that are available in various customisable configurations. With your enquiries and for more information, please call +966 596060321.